134
LCD PC E
LCD PC E
-
-
8590 MAINTENANCE
8590 MAINTENANCE
4. Remove the housing shielding. (See the step 2 of section 2.2.2 disassembly)
5. Disconnect the power wires from system board. Then remove two screws fastening the power supply. (Figure 2-42)
6. Disconnect the power wire from hard disk drive. (Figure 2-43)
Figure 2-42 Disconnect the power wires
and remove two screws
Reassembly
1. Reconnect three power wires.
2. Replace the power supply and secure with two screws.
3. Fit the plate back to base housing with the door.
4. Fit the power & HDD’s compartment cover and secure with three screws.
5. Replace the housing shielding and CPU cover. (See step 3, 4 of section 2.2.2 reassembly).
Figure 2-43 Disconnect the power wire
To Next Page
Loading...