Installation and Configuration Guide
44
Command Descriptions
The 'module' and 'debug' commands are not covered here. Commands in the 'module' scope
are likely to change depending on which software modules are present in the Handset Gateway
software system, while the debugger is intended for engineering and advanced support use
only, and is a large enough subject to command its own documentation.
Global Scope
Commands in the 'global' scope are always available and can be used from anywhere. There
is no security restriction over these commands.
cd
Usage:
cd -h
cd path
This changes the scope to that specified. The 'path' argument can be relative to the current
position or absolute. Absolute paths begin with the '/' character. The path can contain the
special scope names '..', meaning 'parent scope', and '.', meaning 'current scope'. Each scope
listed in the path should be separated by a '/' character.
global cd
help
ls
pwd
su
ver
support cr
board
ifconfig
log
manuf
rcp
restart
route
setcfg
stats
temp
sys mac
passwd
trace
wdog
sys/trace flags
To Next Page
Loading...
