Mitel 5340 - Page 32

Mitel IP Phone User Reference Guide Release 4.1
30
ANSWER
You can pull back a call that has been answered by a twinned target phone by
pressing the corresponding Line Appearance key. See “Twinned calls on the
5224/5324 phone” on page 51.
Using the 5224/5324 handset
To answer your phone using the handset, follow these steps:
1. Lift the handset.
You have now answered the call. The LCD displays the caller’s number and
name (if known).
321: Robin Jones
TRANS CONF END
NOTE: If you choose to ignore the incoming call and select a different line
appearance, the line appearance continues to flash but the phone stops
ringing.
2. To end the call while using the handset, choose one of the following:
• Press the END softkey.
• Replace the handset.
Using the 5224/5324 speakerphone
To switch from the handset to the speakerphone during a call, follow these steps:
1. Press the
key.
2. Replace the handset.
To end a call while using the speakerphone, choose one of the
following:
• Press the END softkey.
• Press the
key.
Switching from speakerphone to handset on the 5224/5324 phone
To switch from the speakerphone to the handset during a call, pick up the
handset.
To end the call while using the handset, choose one of the following:
• Press the END softkey.
• Replace the handset.
Answering a second call on the 5224/5324 phone
A second incoming call causes three things to happen: (1) the phone rings once
(only if you are using the handset), (2) a line appearance flashes, and (3) the