Mitel 5340 - Page 39

Mitel IP Phone User Reference Guide Release 4.1
37
To call a number from your incoming calls list, follow these steps (only available if
dialing from the incoming call list is supported by Broadview Networks):
1. Press the CALLS softkey on your phone (or the Incoming Calls List
programmed key).
The most recent call that you received is displayed.
1: John Doe
DIAL TIME QUIT
2. Use the
keys to navigate the list.
3. Press the DIAL softkey to make a call to the displayed number.
The next available Line Appearance is selected and the system will attempt
to dial the displayed number by prefixing it with the appropriate digits for
external dialing (usually "9" or "91" depending on configuration). If the
number can be dialed as such, you will hear ringing once the call has been
placed. If the number cannot be dialed as such, the call will fail and you will
have to dial the number manually, including the proper prefix digits
NOTE: The position of the call in the call list is displayed in front of the phone
number.
The * symbol beside the position of the call means that the call was not
answered.
If the call was answered by a member of your call pickup group, then the call
will show as unanswered (with a *) on your phone and answered (without a *)
on the call pickup group member's phone that answered the call.
*CALLS means that there has been at least one unanswered call since the
last time you viewed the list of calls you received.
Redial on the 5224/5324 phone
Using Redial you can view a list of calls that were made and also redial a number
in that list without using the keypad. The maximum amount of numbers in your
redial list is typically ten but is dependent on Broadview Networks.
To use Redial, follow these steps:
1. Press the REDIAL softkey on your phone, or press
.
The number that you most recently dialed is displayed.
*1: 9-605-223-7865
DIAL TIME QUIT
2. Use the keys to navigate the list (if required).
3. Press the TIME softkey if you wish to display the time and date of the call.
4. Press the NUMBER softkey if you wish to display the number dialed.