Mitel 5340 - Page 46

Mitel IP Phone User Reference Guide Release 4.1
44
You can only log in to an unassigned phone (a phone without a user logged in).
If a phone has a user logged in, you can log the user out by following procedure
in “Logout from the 5224/5324 phone” on page 45. An unassigned phone shows
the following on its display:
Logged Out
ACTIVATE
To log in to a phone, follow these steps:
1. Press the ACTIVATE softkey on an unassigned phone (a phone without a
user logged in).
Extension:
QUIT
2. Enter your extension.
Extension: 314
QUIT
PIN:
ENTER QUIT
3. Enter your PIN.
PIN: *****
ENTER QUIT
4. Press the # key or the ENTER softkey once you have finished entering your
PIN.
The system verifies that the PIN is valid and then it logs you into the phone.
Extension: 314
REDIAL CALLS MENU
NOTE: If you log in while you are logged in to another phone, the system will log
you out of the original phone.
You cannot log in or out, or activate a phone, while the phone is on an active
call.
If you are not logged into a phone, all calls to your extension go directly to
call coverage.
If you have not been assigned the privileges required to log out of your
phone, you are not prompted for a PIN when you log in.
You are not prompted for a PIN when you log in to a phone with a location
extension.