Mitel 5340 - Page 57

Mitel IP Phone User Reference Guide Release 4.1
55
You can pull back a call that has been answered by a twinned target phone by
pressing the corresponding Line Appearance key. See “Twinned calls on the
5212/5312 phone” on page 72.
Using the 5212/5312 handset
To answer your phone using the handset, follow these steps:
1. Lift the handset.
• Alternatively, you may choose to use one of the following methods:
- Press the flashing Line Appearance key.
- Press the
key.
You have now answered the call. The LCD displays the caller's name (if known).
321: Robin Jones
NOTE: If you choose to ignore the incoming call and select a different line
appearance, the line appearance continues to flash but the phone stops
ringing.
Using the 5212/5312 speakerphone
To switch from the handset to the speakerphone during a call, follow these steps:
1. Press the
key.
2. Replace the handset.
3. To end a call while using the speakerphone, press the
key.
Switch from speakerphone to handset on the 5212/5312 phone
To switch from the speakerphone to the handset during a call, pick up the
handset.
To end the call while using the handset, replace the handset.
Answering a second call on the 5212/5312 IP phone
A second incoming call causes three things to happen: (1) the phone rings once
(only if you are using the handset), (2) a line appearance flashes, and (3) the
LCD displays the number and the name of the caller, if the caller is known.
))321: Robin Jones
To answer a second call, choose one of the following:
• Press the flashing Line Appearance key. This puts the active call on
hold and answers the second call.