28 Mitel 6873 SIP
eud-1744/1.4 – R5.0 HF2 – 10.2017
Phoning
Using your phone in hands-free mode
You want other people to join the conversation or to have your hands free
while making the call.
The handsfree mode function activates the loudspeaker and the micro-
phone. Make sure the hands-free microphone is not obstructed. The
sound quality is improved if you set the volume of your phone to a low set-
ting.
Automatic hands-free mode: The function Automatic hands-free allows
you to answer a call without picking up the handset or pressing a key. The
following settings are available. This function Automatic hands-free can
only be activated/deactivated by your system administrator in the MiVoice
Office 400 communication system.
Rejecting a call:
Press the End key or the Ignore softkey during the ringing phase.
➔The connection is rejected and, depending on the system configuration, the
caller either hears the busy tone or is forwarded to a preconfigured destina-
tion.
Deflecting a call:
1. Press the Deflect softkey during the ringing phase.
2. Enter the number to which you want to deflect the call and press the Deflect
softkey.
➔The call is redirected to the destination call number.
Silencing a call:
Press the Silence softkey during the ringing phase.
➔The ringing of the incoming call is put on mute.
Menu Description
Off Automatic hands-free is always deactivated.
Announcement only Automatic hands-free is only activated when you are
receiving an announcement.
On Automatic hands-free is always activated. Your phone
signals an incoming call with two short signal tones and
then switches to hands-free mode automatically.
To Next Page
Loading...
Need help?
General
