42 Mitel 6873 SIP
eud-1744/1.4 – R5.0 HF2 – 10.2017
Phoning
Take (pick up own call)
You want to transfer a call from one phone to another without interrupting
the connection (for example, from a desk phone to a cordless phone).
The take function can be used to transfer calls between your phones.
Requirements: You are using the one number user concept (see chapter
"One number user concept", page 8
).
You must save this function to a configurable key using Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 92).
Call transfer with prior notice (you are in a call):
1. Press the Xfer softkey.
2. Enter the call number of the second call party and press the Dial softkey (or
press the corresponding busy lamp field).
➔The second call party is called, the first call party is put on hold ( is dis-
played, LED of the line key flashes).
3. Wait until the person has answered the call.
➔If the second user does not answer, you can cancel the second call using
the softkey Cancel and recommence the first call by pressing Pick up.
4. Announce the call party.
5. Put the handset on-hook.
➔Your first call partner and the other person are now connected with each
other.
Call transfer without prior notice (you are in a call):
1. Press the Xfer softkey.
2. Enter the call number of the second call party and press the Dial softkey (or
press the corresponding busy lamp field).
➔The second call party is called; first call party is put on hold.
3. Wait for the first ring tone.
4. Put the handset on-hook.
➔The other party is then called directly by your first call partner.
➔Recall: If the other party does not answer, the call comes back to your
phone.
Note: You can change the procedure by first starting an enquiry call before call trans-
fer.
To Next Page
Loading...
Need help?
General
