Phoning
Mitel 6873 SIP 73
eud-1744/1.4 – R5.0 HF2 – 10.2017
Setting functions by remote control
This section explains how you can alter your phone’s settings even if
you are not directly at your phone.
You are not at your desk and want to set various functions on your phone
from a different phone.
You can activate/deactivate many of your phone's functions by remote
control from a different phone.
The remote control is initiated using a special function code. You must
then enter the function commands and function codes (see chapter "Over-
view of available functions", page 55).
Activating/deactivating PIN call:
Press the function key for PIN call / PIN call rebook.
➔Function is activated/deactivated, LED on the function key is switched on/off.
Using remote control from a third-party phone:
1. Enter function code #06.
2. Enter your phone number.
3. Enter your PIN.
4. Enter the function code for activating/deactivating the function you want.
Pick up the handset.
➔You hear the acknowledgement tone.
Put the handset on-hook.
➔The function is activated/deactivated.
Note: The default PIN setting ‘0000’ is not accepted (for more information on the PIN,
see chapter "Changing the PIN", page 82
).
To Next Page
Loading...
Need help?
General
