52
C
USTOMIZING YOUR PHONE AUDIO
NOTE:
1. On 6920 IP Phone by default the Audio mode is set to Speaker. When the Headset is connected to
the phone, user must change the Audio mode to Headset or Speaker/Headset or Headset/Speaker.
2. If a headset is not connected and the user presses the speaker/headset key, the phone goes to
speaker mode regardless of the audio mode.
3. If a headset is not connected and the user presses programmable key, the phone goes to speaker
mode regardless of the audio mode.
Configuring the Audio Mode Using the IP Phone UI
1. Press on the phone to enter the Options List.
2. Navigate to the Audio > Audio Mode option and press the select button or Select softkey.
Audio Mode Option Description
Speaker This is the default setting. Calls can be made or
received using the handset or handsfree
speakerphone. In handset audio mode, pressing
the button on the phone switches to
handsfree speakerphone. In Speaker audio
mode, lift the handset to switch to the handset.
Headset Choose this setting if you want to make or receive
all calls using a handset or headset. Calls can be
switched from the handset to headset by pressing
the button on the phone. To switch from
the headset to the handset, lift the handset.
Speaker/Headset Incoming calls are sent to the handsfree
speakerphone first when the button is
pressed. By pressing the button again, you can
switch back and forth between the handsfree
speakerphone and the headset. At anytime, lifting
the handset switches back to the handset from
either the handsfree speakerphone or the
headset.
Headset/Speaker Incoming calls are sent to the headset first when
the button is pressed. By pressing the
button again, you can switch back and forth
between the headset and the handsfree
speakerphone. At anytime, lifting the handset
switches back to the handset from either the
headset or the handsfree speakerphon
To Next Page
Loading...
