Phoning
Mitel 6940 SIP 37
eud-1765/2.0 – R6.0 – 06.2018
Dialing with a configurable key/ busy lamp field
You want to call someone whose phone number is stored under a configu-
rable key or a busy lamp field.
To find out how to configure a configurable key, refer to chapter "Configur-
ing keys", page 101.
Dialing with the line key
You can make a call through a line key.
Your phone is equipped with two dedicated line keys (two top softkeys con-
figured as line keys).
Your system administrator can set up to ten additional line keys (twelve in
total). The actual number of line keys depends on the system configura-
tion. Press a set line key directly or move you finger from the right to left in
the area to the right of the left softkeys and select the desired line key. The
status line at the top left will show the dialed line number (L1, L2 etc.). If a
line is free, the New Call softkey at the bottom left of the display can be
used.
Line keys are stored on configurable keys by your system administrator
(see chapter "Line keys on a key telephone", page 76
).
Phoning with the handset:
1. Pick up the handset.
2. Press the desired configurable key/busy lamp field.
➔The phone number is dialed.
Using your phone in hands-free mode:
Press the desired configurable key/busy lamp field.
➔The phone number is dialed.
Dialing with the line key:
Enter the phone number.
Press a free line key.
➔The phone number is dialed. The LED on the line key lights up.
To Next Page
Loading...
