Mitsubishi Electric FX3U-ENET-ADP - PLC Side I;F Detailed Setting

8 The Operation of GX Works2
8.5 Online Function
96
FX3U-ENET-ADP User's Manual
2) PLC side I/F Detailed Setting of PLC Module screen
On the "PLC side I/F Detailed Setting of PLC Module" screen, set the connection type (direct connection
to the Ethernet port or connection via a hub) and others. For connection via a hub, the method to directly
enter the IP address and host name and the method to search for connected PLC units and select one
from the list are available.
Explanation of the screen is shown below.
Setting Description
PLC Mode FXCPU is displayed.
Ethernet Port Direct
Connection
*1
Check this item to select direct connection to the Ethernet port.
Connection via HUB
*1
Check this item to select connection via a hub.
IP Address
*2
When the item "Connection via HUB" is checked, specify the IP address of the connection destination.
To enter the IP address, there is another method to search for FXCPU units on the network and select one from
the list of found FXCPU units.
Host Name
*2
When the item "Connection via HUB" is checked, specify the host name of the connection destination.
IP Input Format
Specify the input format used to set the IP address.
[Setting]
•Decimal
• Hexadecimal