E-62
8 Examples of Practical Programs
FX
3S
/FX
3G
/FX
3GC
/FX
3U
/FX
3UC
PLC User's Manual - Analog Control Edition
FX3U-4DA (4-channel Analog Output)
8.3 Example of Program for Table Output Operation (Pattern Output Operation)
•For FX3G/FX3GC/FX3U/FX3UC Series PLCs
*1. The output mode setting is retained in the EEPROM of the FX
3U-4DA. For this reason, even if the
sequence program is deleted, the previously set functions will still be valid.
*2. After setting the output mode, set the data writing time (waiting time) to 5 seconds or more for each
setting. After the output mode is specified, and the same output mode is used, it is not necessary to
set the output mode and the waiting time (T0 K50).
*3. Execute the data table transfer command as a pulse execution type instruction.
T0
Channel-1 output pattern
Number of repetitions of output of table
from channel 1
X000
Start table output function (channel 1)
Turning-off of M1 when output of table from
channel 3 is stopped
Turning-on of M1 when table is output from
channel 3
Number of repetitions of output of table
from channel 3
Number of head device in data table
Data table transfer command
*3
Readout of data table transfer command
Turning-on of M0 At the completion of transfer
of data table
Start table output function (channel 3)
Turning-on of M1 when table is output from
channel 3
Stop table output function
Restart of table output function (channel 3)
M10
SET M0
SET M1
M1
M1
RST M1
X002
M1
SET M1
Channel-3 output pattern
X001
X000
M8002
M8000
K50
*2
T0
Specification of output modes of channels 1 to 4
*1
Initial pulse
RUN monitor
K0 K1
P
K0 HF2F0
K81 K1
P
K0 K1
K83 K1
P
K0 K2
K85 K1
P
K0 K5
K87 K1
P
K0 K0
K98 K1
P
K0 K5000
K99 K1
P
K0 H0001
K99 K1K0 D100
D100 K4M10
K80 K1
P
K0 H0100
K80 K1
P
K0 H0101
K80 K1
P
K0 H0000
K80 K1
P
K0 H0100
Continued
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 79
TO
FNC 78
FROM
FNC 12
MOV
To Next Page
Loading...
