E-64
9 Troubleshooting
FX
3S
/FX
3G
/FX
3GC
/FX
3U
/FX
3UC
PLC User's Manual - Analog Control Edition
FX3U-4DA (4-channel Analog Output)
9.1 PLC Version Number Check
9. Troubleshooting
This chapter describes the troubleshooting methods and error codes.
If the D/A conversion data is not output, or if the proper digital value is not output, check the following items:
• Wiring
• Program
• Error status
9.1 PLC Version Number Check
• Any versions (from Ver. 1.00 (initial version) to the latest version) of the FX3G Series are compatible.
• Any versions (from Ver. 1.40 (initial version) to the latest version) of the FX
3GC Series are compatible.
• Any versions (from Ver. 2.20 (initial version) to the latest version) of the FX
3U Series are compatible.
• Check the version number of FX
3UC Series. The version number should be 1.30 or later.
→ For a detailed description of the version check method,
refer to A. Common Items Subsection 5.1.2.
9.2 Wiring Check
Check the wiring as follows:
1. Power
FX3U-4DA needs driving power. Verify that the power supply line is properly connected. Also check that the
24 V indicator lamp of FX
3U-4DA is on.
2. Analog output line
Use the 2-core twisted shielded cable for the analog output line. In addition, be sure to separate the analog
output line from the other motive power lines or inductive lines.
→ For a detailed description of wiring, refer to Chapter 3.
9.3 Program Check
Check the program as follows:
1. Check the output mode and output data.
Check that data has been set correctly in BFM#0 to #4.
2. Check the settings.
Check that the offset data (BFM#10 to #13), gain data (BFM#14 to #17), upper/lower limit function setting
(BFM#38) and table output function start/stop setting (BFM#80) are correct.
To Next Page
Loading...
