Mitsubishi Electric MELSEC iQ-R RD78G4 - Page 112

110
4 ADVANCED SYNCHRONOUS CONTROL
4.3 Clutch
■Address mode
The clutch is turned ON when the reference address reaches "Clutch ON address".
The movement amount after passing through the ON address is calculated as the output movement amount of the clutch
based on the reference address passing through, thereby controlling the clutch with an accurate movement amount.
■High speed input request
The clutch is turned ON when the high speed input request [DI] turns ON.
The following actions are required when using the high speed input request.
• Set the signal No. for the "High speed input request signal" clutch control setting.
• Set the external command signal used in "[Pr.95] External command signal selection", "4: High speed input request" in
"[Pr.42] External command function selection" and "1: Validates an external command" in "[Cd.8] External command valid"
for the applicable axis.
Item Main shaft clutch Auxiliary shaft clutch
Reference address The current value specified in "[Pr.406] Main shaft
clutch reference address setting"
("[Md.400] Position value after composite main
shaft gear" or "[Md.401] Position value per cycle
after main shaft gear")
The current value specified in "[Pr.423] Auxiliary
shaft clutch reference address setting"
(Auxiliary shaft current value (servo input axis
position value/synchronous encoder axis position
value) or "[Md.402] Position value per cycle after
auxiliary shaft gear")
Clutch ON address [Pr.407] Main shaft clutch ON address [Pr.424] Auxiliary shaft clutch ON address
Clutch ON/OFF status [Md.420] Main shaft clutch ON/OFF status [Md.423] Auxiliary shaft clutch ON/OFF status
t
t
Movement amount after
clutch output
Clutch ON address
Clutch ON/OFF status
Current value specified in
clutch reference address
setting
t
t
Movement amount after
clutch output
[Cd.8] External command valid
Current value before
clutch input
Clutch ON/OFF status
High speed input request
[DI]