APPX
Appendix 1 List of Buffer Memory Addresses (for Synchronous Control)
169
A
■Synchronous parameter: Speed change gear
n: Axis No. - 1
■Synchronous parameter: Output axis
n: Axis No. - 1
■Synchronous parameter: Synchronous control initial position
n: Axis No. - 1
Item Fetch cycle Buffer memory address
Axis 1 to axis 16
[Pr.434] Speed change gear At operation start (Synchronous control) 36460+200n
[Pr.435] Speed change gear smoothing time constant At operation start (Synchronous control) 36461+200n
[Pr.436] Speed change ratio: Numerator Operation cycle 36462+200n
36463+200n
[Pr.437] Speed change ratio: Denominator Operation cycle 36464+200n
36465+200n
Item Fetch cycle Buffer memory address
Axis 1 to axis 16
[Pr.438] Cam axis cycle unit setting At operation start (Synchronous control) 36470+200n
[Pr.439] Cam axis length per cycle At operation start (Synchronous control)
/ At completion of the condition (Passing
through the 0th point of cam data)
36472+200n
36473+200n
[Pr.440] Cam No. At operation start (Synchronous control)
/ At completion of the condition (Passing
through the 0th point of cam data)
36474+200n
[Pr.441] Cam stroke amount At operation start (Synchronous control)
/ At completion of the condition (Passing
through the 0th point of cam data)
36476+200n
36477+200n
[Pr.442] Cam axis length per cycle change setting At operation start (Synchronous control) 36471+200n
[Pr.444] Cam axis phase compensation advance time Operation cycle 36482+200n
36483+200n
[Pr.445] Cam axis phase compensation time constant At operation start (Synchronous control) 36484+200n
[Pr.446] Synchronous control deceleration time At operation start (Synchronous control) 36485+200n
[Pr.447] Output axis smoothing time constant At operation start (Synchronous control) 36486+200n
Item Fetch cycle Buffer memory address
Axis 1 to axis 16
[Pr.460] Setting method of position value per cycle after main shaft gear At operation start (Synchronous control) 36500+200n
[Pr.461] Setting method of position value per cycle after auxiliary shaft gear At operation start (Synchronous control) 36501+200n
[Pr.462] Cam axis position restoration object At operation start (Synchronous control) 36502+200n
[Pr.463] Setting method of cam reference position At operation start (Synchronous control) 36503+200n
[Pr.464] Setting method of cam axis position value per cycle At operation start (Synchronous control) 36504+200n
[Pr.465] Position value per cycle after main shaft gear (Initial setting) At operation start (Synchronous control) 36506+200n
36507+200n
[Pr.466] Position value per cycle after auxiliary shaft gear (Initial setting) At operation start (Synchronous control) 36508+200n
36509+200n
[Pr.467] Cam reference position (Initial setting) At operation start (Synchronous control) 36510+200n
36511+200n
[Pr.468] Cam axis position value per cycle (Initial setting) At operation start (Synchronous control) 36512+200n
36513+200n
To Next Page
Loading...
