174
APPX
Appendix 1 List of Buffer Memory Addresses (for Synchronous Control)
■Cam operation control data: Cam data operation
■Cam operation control data: Cam auto-generation
*1 The item details on the auto-generation parameter are shown below.
• Cam auto-generation parameter for rotary cutter
Item Fetch cycle Refresh cycle Buffer memory
address
[Cd.600] Cam data operation request Main cycle 45000
[Cd.601] Operation cam No. At request (Cam data
operation request)
45001
[Cd.602] Cam data first position At request (Cam data
operation request)
45002
[Cd.603] Number of cam data operation points At request (Cam data
operation request)
45003
[Cd.604] Cam data format At request (Cam data
operation request)
At completion of the
condition (Completion of
cam data operation)
45004
[Cd.605] Cam resolution/coordinate number At request (Cam data
operation request)
At completion of the
condition (Completion of
cam data operation)
45005
[Cd.606] Cam data starting point At request (Cam data
operation request)
At completion of the
condition (Completion of
cam data operation)
45006
[Cd.607] Cam data value At request (Cam data
operation request)
At completion of the
condition (Completion of
cam data operation)
45008 to 53199
Item Fetch cycle Buffer memory address
[Cd.608] Cam auto-generation request Main cycle 53200
[Cd.609] Cam auto-generation cam No. At request (Cam data auto-generation
request)
53201
[Cd.610] Cam auto-generation type At request (Cam data auto-generation
request)
53202
[Cd.611] Cam auto-generation data
*1
At request (Cam data auto-generation
request)
53204 to 53779
Details Buffer memory address
Resolution 53204
Sheet length 53206
53207
Sheet synchronous width 53208
53209
Synchronous axis length 53210
53211
Synchronization starting point 53212
53213
Synchronous section acceleration ratio 53214
To Next Page
Loading...
