3 - 12
*1: The remote input refresh area indicates the area to be used when auto refresh is set to the input (X) in the
CC-Link IE Controller Network, MELSECNET/H, or CC-Link.
Data in the remote input refresh area will be refreshed automatically during END processing.
*2: Data in the GX Developer input area can be turned on/off by the following operation.
• Test operation by GX Developer
• Writing data from a network module
• Writing data from an external device using the MC protocol
*3: Data in the output (Y) device memory can be turned on/off by the following operation.
• Test operation by GX Developer
• Writing data from an external device using the MC protocol
• Writing data from a network module
To Next Page
Loading...
Need help?
General
