Mitsubishi 00JCPU User Manual

11 - 10
11.2.3 Procedure for Writing One Program
This section describes a procedure for writing a program to the program memory. ( Section 5.2.2)
Follow the procedure below and then the procedure provided in Section 11.2.5 before storing the program in the
standard ROM or memory card for boot operation.
In the following procedure, indicates an operation on the CPU module side.
YES
NO
1)
Use the initial
device value?
Set the device memory.
Set the initial device value range.
Set a file name for initial device value in the
PLC file tab of the PLC parameter dialog box.
Set the parameter-valid drive with the DIP
switches (SW2, SW3).
*2
*1
NO
YES
Start
Start GX Developer.
Set the project.
Change the number of
device points?
Change the number of device points in the
Device tab of the PLC parameter dialog box.
Create a program to be executed
in the CPU module.
Ladder (writing) screen
GX Developer Version 8 Operating Manual
GX Developer Version 8 Operating Manual
Connect the personal computer to which GX
Developer is installed to the CPU module.
Section 6.26
Section 6.26
Section 6.26

Mitsubishi 00JCPU Specifications

General

Brand	Mitsubishi
Model	00JCPU
Category	Controller
Language	English