11 - 9
CHAPTER11 PROCEDURES FOR WRITING PROGRAM TO CPU MODULE
1
2
11
4
5
6
7
8
11.2 High Performance Model QCPU, Process CPU, and Redundant CPU
11.2.2 Hardware Check
For installation and mounting procedures of the CPU module, refer to the following.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)
Figure 11.4 Hardware check flowchart
YES
YES
NO
NO
1)
Power off the programmable controller and
then on or reset the CPU module.
Set the RUN/STOP switch to RUN to change
the CPU module in the RUN status.
Is the RUN LED on?
Is the ERR. LED off?
To Section 11.2.3
Check the error cause in the System Monitor
screen displayed by selecting [Diagnostics]
[System Monitor] in GX Developer or in the
"PLC diagnostics" screen and remove the error.
QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
Please consult your local
Mitsubishi representative.
To Next Page
Loading...
Need help?
General
