Mitsubishi FX3U-422-BD - Connection Diagram

B-22
FX Series PLC User's Manual - Data Communication Edition
N:N Network
4 Wiring
4.3 Connection Diagram
4.3 Connection Diagram
Use one-pair wiring for an N:N Network.
4.4 Grounding
Grounding should be performed as stated below.
• The grounding resistance should be 100Ω or less.
• Independent grounding should be performed for best results.
When independent grounding can not be performed, perform "shared grounding" as shown in the following
figure.
→ For details, refer to the Hardware Edition of each series.
• The grounding wire size should be AWG 14 (2 mm
2
) or larger.
• The grounding point should be close to the PLC, and all grounding wires should be as short as possible.
Terminal
resistor:
110 Ω
Class-D grounding
(resistance: 100 Ω or less)
*1
Class-D grounding
(resistance: 100 Ω or less)
*1
FX2NC-485ADP
SDA
SDB
RDA
RDB

SG
FX
3G-485-BD
FX
3U -485-BD
FX
2N-485-BD
FX1N-485-BD
FX
3U-485ADP(-MB)
SDA
SDB
RDA
RDB
SG
FX
0N-485ADP
SDA
SDB
RDA
RDB
LINK
SG
FG
*2
Terminal
resistor:
110 Ω
Communication
equipment in
accordance
RS-485
SDA
SDB
RDA
RDB
LINK
SG
*3 *3
Make sure to perform Class-D grounding to the shield of a twisted pair cable connected to the FX2N-485-BD, FX1N-485-BD,
FX
3U-485-BD, FX3G-485-BD, FX2NC-485-ADP or FX3U-485ADP(-MB).
FG Make sure to connect the terminal to the (grounding) terminal in the PLC requiring Class-D grounding.
If the grounding terminal is not provided in the PLC, perform Class-D grounding directly.
Make sure to provide a terminal resistor at the end of each line.
 The FX
3U-485-BD, FX3G-485-BD and FX3U-485ADP(-MB) have a built-in terminal resistor. Set the terminal resistor selector
switch accordingly.
 The FX
0N -485ADP, FX 2NC -485ADP, FX 2N -485-BD and FX 1N -485-BD are supplied together with terminal resistors.
*2
*1
*3
PLC
Other
equipment
PLC
Other
equipment
PLC
Other
equipment
Shared grounding
Good condition
Common grounding
Not allowed
Independent grounding
Best condition