E-61
FX Series PLC User's Manual - Data Communication Edition
Inverter Communication
6 Communication Setting in FX Programmable Controller
6.3 Communication Setting Using Parameter Method (FXGP/WIN)
A
Common Items
B
N:N Network
C
Parallel Link
D
Computer Link
E
Inverter
Communication
F
Non-Protocol
Communication
(RS/RS2 Instruction)
G
Non-Protocol
Communication
(FX
2N
-232IF)
H
Programming
Communication
I
Remote
Maintenance
Apx.
Discontinued
models
2. When there are already parameter settings
The existing communication setting contents are displayed.
2 Adjusting serial setting (parameter)
Execute the communication setting as shown below.
[1] Set "Protocol" to "RS instruction," "Data bits" to "7," "Parity" to "Even," and "Stop bits" to "1".
[2] Set "Transfer speed [bps]" to either "4800," "9600" or "19200," and make sure that the set value
here is the same as the set value in the inverters.
[3] Ignore these items.
3 Writing a sequence program (parameters) to the PLC
Select [PLC] - [Transfers] - [Write] from the toolbar, and click [OK].
[1]
[2]
[3]
To Next Page
Loading...
