ELECTRICAL SYSTEM
12-52
3.4.2 Verification after reassembly (ETS type)
(1) After starting the engine, turn the starter switch key to
the OFF position, and make sure that the solenoid
activates and the engine stops.
(2) During engine start, turn the starter switch key to the
ON position, and make sure that the solenoid activates
and the engine enters a stopped state.
(3) Turn the starter switch key from the OFF position to
ON, and then to START position. Make sure that the
solenoid activates with the key turned to ON and that
the solenoid instantly stops to activate with the key
turned to START.
To Next Page
Loading...
Need help?
General
