FX-TRN-BEG-E Preparation befor Operating 2
C-7
2.3 Opening a project
Open an existing project from a floppy disk or hard disk.
1) Select "Project"
→
"Open project".
2) When the ’Open’ dialog box is displayed, select a project to open.
You can open only one project at a time. If you try to open another project while editing a
project, the message is displayed asking if you want to save it.
POINT
For reading and handling of model answers, refer to the ’Introduction Section’ in this manual.
Select a project.
The place in which the project
is located is displayed.
The selected project name is
displayed.
To Next Page
Loading...
