Mitsubishi MELSEC-F FX-TRN-BEG-E - Writing STL Instruction

FX-TRN-BEG-E Operation 3
C-13
3.1.2 Writing STL Instruction
1) Place the cursor where the STL instruction is to be written.
2) Press the [F8] key. The ’Enter symbol’ dialog box is displayed.
3) Type STL S0.
4) Click the [OK] button.
Writing the RET instruction.
1) Draw a vertical line from the STL symbol and place the cursor where the RET instruction is
to be written.
2) Press the [F8] key. The ’Enter symbol’ dialog box is displayed.
3) Type RET.
4) Click the [OK] button.
Both capital letters and small
letters can be used.
Type the state number
Write the RET instruction after drawing a vertical line
from the STL instruction.
Both capital letters and small
letters can be used.