Mitsubishi MELSEC-F FX-TRN-BEG-E - Application Instruction

FX-TRN-BEG-E Operation 3
C-14
3.1.3 Application instruction
The following is how to input application instructions.
The MOV instruction and the LD= instruction are explained up as examples.
• MOV instruction
1) Place the cursor where the MOV instruction is to be written.
Press the [F8] key. The ’Enter symbol’ dialog box is displayed.
Type MOV K100 D0.
2) Click the [OK] button.
Write the MOVP instruction and the DMOVP instruction as follows.
• LD= instruction
1) Place the cursor where the LD= instruction is to be written.
Press the [F8] key. The ’Enter symbol’ dialog box is displayed.
Type LD= K100 D20.
2) Click the [OK] button.
POINT
For the list of available instructions and input procedures, refer to the Appendix 1.
MOVP instruction
DMOVP instruction
Both capital letters and small
letters can be used.