Mitsubishi MELSEC-F FX-TRN-BEG-E User Manual

INTRODUCTION
A-1
INTRODUCTION
The method to set up the software and the flow of the lessons are explained in this section.
Please read to improve the effectiveness of the later lessons.
Contents
1. Introduction........................................................................................... A-3
2. Outline of the Lesson Plan ................................................................... A-5
2.1 Outline .................................................................................................................A-5
2.2 Setup of Software................................................................................................A-6
2.3 Begin to Learn PLC Programming.......................................................................A-9
2.3.1 Start the Training Software........................................................................................A-9
2.3.2 User Registration.......................................................................................................A-9
2.4 Configuration of Main Menu ..............................................................................A-10
2.5 Configuration of Training Screen.......................................................................A-11
2.5.1 Training Screen .......................................................................................................A-11
2.5.2 3-D Virtual Manufacturing Cell ................................................................................A-12
2.5.3 Remote Control .......................................................................................................A-13
2.5.4 Ladder Program Area..............................................................................................A-13
2.5.5 Guidance Window ...................................................................................................A-14
2.5.6 I/O Image Table for Virtual PLC ..............................................................................A-16
2.5.7 Operation Panel ......................................................................................................A-16
2.6 Writing a Program..............................................................................................A-17
2.6.1 Preparation for Ladder Editing ................................................................................A-17
2.6.2 Reading out the Model Answer ...............................................................................A-18
2.7 Operation Confirmation .....................................................................................A-19
2.7.1 Program Transfer ....................................................................................................A-19
2.7.2 Adjustment of Simulation Speed .............................................................................A-19
2.8 Self-judgement ..................................................................................................A-20
2.9 Exit.....................................................................................................................A-21
FX-TRN-BEG-E

Mitsubishi MELSEC-F FX-TRN-BEG-E Specifications

General

Brand	Mitsubishi
Model	MELSEC-F FX-TRN-BEG-E
Category	Controller
Language	English