Mitsubishi MELSEC-F FX-TRN-BEG-E - Printing Ladder Program Contents

FX-TRN-BEG-E Operation 3
C-24
3.5 Print
This chapter explains how to print the programs and device comments.
1) Select "View"
→
"Comment" to display device comments in the ladder program area.
2) Select "Project"
→
"Print".
Printing is executed according to the device comment display status as shown below.
POINT
• All the programs are printed.
• If printing is executed during monitoring, the contents of the monitor display are also
printed.
Display in ladder program area Printing result
Each device comment is displayed in up to 16
characters.
Each device comment is printed in up to 16
characters.
Each device comment is displayed in up to 32
characters.
Each device comment is printed in up to 32
characters.
Device comments are not displayed. Device comments are not printed.
・
・
・
・
・
・
・
・
・