Mitsubishi MELSEC-F FX-TRN-BEG-E - Conversion

FX-TRN-BEG-E Operation 3
C-15
3.1.4 Conversion
The programs you write should be converted into the form which can be processed by the
virtual PLC.
This is how to convert them.
1) After writing the programs, press the [F4] key.
2) The programs are converted. The background of the programs should be displayed in white.
If there is an incorrect program, an error message is displayed and the part is displayed in
yellow. Correct the program.
POINT
Programs you write are determined when they are converted.
An incorrect program is displayed
in yellow.