Mitsubishi MELSEC-F FX-TRN-BEG-E - Cut, Copy and Paste

FX-TRN-BEG-E Operation 3
C-17
• Writing and deleting ines
Write ruler lines as follows.
1) Press the [F10] key first.
2) When writing a horizontal line, press the [Shift] + [
→
] keys to move the cursor. When
writing a vertical line, press the [Shift] + [
↓
] keys to move the cursor.
3) When you release the [Shift] key, a horizontal or vertical line is written.
Delete lines as follows.
1) Press the [Alt] + [F9] keys first.
2) When deleting a horizontal line, press the [Shift] + [
→
] keys to move the cursor. When
deleting a vertical line, press the [Shift] + [
↓
] keys to move the cursor.
3) When you release the [Shift] key, a horizontal or vertical line is deleted.
POINT
Only horizontal and vertical lines can be deleted using this method. Even if you operate the
above explained procedure on a contact, the contact is not deleted.
3.2.2 Cut, Copy and Paste
The method to cut, copy and paste a program is explained here.
You can efficiently edit programs using these functions.
1) Press the [Shift] + [
→
] keys to select the range to be cut or copied.
2) Select "Edit"
→
"Cut" or "Edit"
→
"Copy".
Shift
+
→
→→
→
Shift
+
→
→→
→