FX-TRN-BEG-E Operation 3
C-12
• How to write basic instructions
The figure below shows the function keys, the device numbers and the set values for basic
instructions.
POINT
• If you double-click a contact, the instruction symbol and the device entered are displayed in
the dialog box ’Enter symbol’.
The contact data can be changed.
• You can input basic instructions not only by pressing the function keys but also by typing
letters. For its method, refer to the Appendix 1.2.
F7 Y0
OUT instruction
F7 T0 K50
Timer
F7 C0 K20
Counter
F8 SET Y1
SET
F8 PLS M1
PLS
F6 Y0
NO contact OR
Shift F9
Vertical line
*1
F9
Horizontal line
*1
F8
XXXX
: Function key
: Characters to type
Shift X1F5
NC contact
*1 Type a number for the length after pressing key.
F9
Press [Shift] + [F6].
Double-click it.
Changed to NC contact.
Example:
To Next Page
Loading...
