FX-TRN-BEG-E Outline of the Lesson Plan 2
A-8
5) Determine the program folder name.
• The training software will be installed in
this program folder or another folder name
can be entered.
A folder of the same name would be
overwritten if it exists.
• Click [Next] to start the installation.
6) Complete the setup.
• It takes about 10 seconds to perform
installation. If you take the CD out of the
CD-ROM drive or shut down your
computer during installation, the software
will not install properly.
• Click the [Finish] button to finish the setup.
* Take out the CD and carefully store it for
later use.
7) Program folders are displayed.
• When installation is completed, the
window shown on the left is displayed.
Did you install
it properly?
To Next Page
Loading...
