Mitsubishi MELSEC-F FX-TRN-BEG-E - FX PLC Training Exercises Catalog; Exercise Listing and Classification; Introduction to FX Series PLC Learning; Basic PLC Programming Concepts

EXERCISES
B-1
EXERCISES
This section gives details about each exercise, the exercise objectives, and the I/O device
assignments.
Contents
List of Exercises
A: Learn the FX Series PLC!
B: Let's Study the Basics
C: Easy Does It!
Exercise Objective
Difficulty
level
Object to
Control
Chapter
A-1.Introduction to the FX
Series PLC
Look at a typical operation sequence
and structure of the training software.
1 Door 1.1
A-2.Application Examples
for the FX Series PLC
Look at field application examples for
the FX Series PLC.
1

1.2
A-3.Let's play a Little!
Let’s play a little and start writing a
program!
1Conveyor1.3
Exercise Objective
Difficulty
level
Object to
Control
Chapter
B-1.Basic I/O Program Learn input and output programs. 1
Indicator
lamp
2.1
B-2.Standard Program
Learn a latched output program and
SET/RST program.
1
Indicator
lamp
2.2
B-3.Control Precedence
Program
Learn an interlock program which
controls conflicting operations.
1
Traffic light
with two
signal lamps
2.3
B-4.Reading the Input
Status
Learn how to initiate instructions at the
detection of rising or falling edge of a
pulse.
2Conveyor2.4
Exercise Objective
Difficulty
level
Object to
Control
Chapter
C-1.Basic Timer Operation Learn the On-delay time function. 1 Door 3.1
C-2.Application Timer
Program - 1
Learn the Off-delay time function and
the one shot timer.
1 Door 3.2
C-3.Application Timer
Program - 2
Learn a "flicker" program executed by
timers.
2
Traffic light
with two
signal lamps
3.3
C-4.Basic Counter
Program
Learn control methods using counters. 2 Conveyor 3.4
FX-TRN-BEG-E