5. HOW TO USE THE PROGRAM
5 - 52
(2) Timing chart
The following shows a timing chart after a program containing a "ZRT" command is selected.
ON
OFF
MEND (Travel completion)
ON
OFF
CPO (Rough match)
ON
OFF
Servo motor speed
MD0
(Operation mode selection 1)
ON
OFF
DOG (Proximity dog)
ZP
(Home position return completion)
ON
OFF
ON
OFF
ON
OFF
ST1 (Forward rotation start)
ST2 (Reverse rotation start)
3 ms or shorter
Home position return speed
Deceleration time constant
Creep speed
Home position
shift distance
Home position return position data
5 ms or longer
Acceleration time constant
Proximity dog
ON
OFF
Z-phase
PED (Position end)
ON
OFF
Reverse rotation
0 r/min
Forward rotation
The setting value of [Pr. PT08 Home position return position data] is used as the position address at the
home position return completion.
To Next Page
Loading...
