6. APPLICATION OF FUNCTIONS
6 - 33
(2) Example of the simultaneous start function with contact input or via the Modbus RTU communication
(a) Configuration example
To synchronize the vertical motion of the vertical axis (axis 2) with the position of the horizontal axis
(axis 1) as shown below, input the positioning commands for axis 1 to axis 2 as well. (Set the same
point table data for the axis 1 and 2.)
Flow of belt conveyors
Axis 2 (vertical axis)
Axis 1 (horizontal axis)
Fig. 6.5 System configuration example
To Next Page
Loading...
