Mitsubishi MR-JE-100A - Page 286

7. PARAMETERS
7 - 11
7.1.6 Extension setting 3 parameters ([Pr. PF_ _ ])
POINT
The following parameters are used for Modbus RTU communication. For details,
refer to "MR-JE-_A Servo Amplifier Instruction Manual (Modbus RTU
communication)".
[Pr. PF45 Function selection F-12]
[Pr. PF46 Modbus RTU communication time out selection]
No. Symbol Name
Initial
value
Unit
Control
mode
CP CL
PF01 For manufacturer setting 0000h
PF02 0000h
PF03 0000h
PF04 0
PF05 0
PF06 0000h
PF07 1
PF08 1
PF09 *FOP5 Function selection F-5 0000h
PF10 For manufacturer setting 0000h
PF11 0000h
PF12 10000
PF13 100
PF14 100
PF15 2000
PF16 0000h
PF17 10
PF18 0000h
PF19 0000h
PF20 0000h
PF21 DRT Drive recorder switching time setting 0 [s]
PF22 For manufacturer setting 200
PF23 OSCL1 Vibration tough drive - Oscillation detection level 50 [%]
PF24 *OSCL2 Vibration tough drive function selection 0000h
PF25 CVAT Instantaneous power failure tough drive - Detection time 200 [ms]
PF26 For manufacturer setting 0
PF27 0
PF28 0
PF29 0000h
PF30 0
PF31 FRIC Machine diagnosis function - Friction judgment speed 0 [r/min]
PF32 For manufacturer setting 50
PF33 0000h
PF34 0000h
PF35 0000h
PF36 0000h
PF37 0000h
PF38 0000h
PF39 0000h
PF40 0
PF41 0
PF42 0
PF43 0