Mitsubishi Q01CPU User Manual

5
POWER SUPPLY MODULE
5.2 Specifications
5.2.1 Power supply module specifications
5 - 13
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
GENERAL SPECIFICATIONS
4
HARDWARE SPECIFICATIONS OF THE CPU MODULE
5
POWER SUPPLY MODULE
6
BASE UNIT AND EXTENSION CABLE
7
MEMORY CARD AND BATTERY
8
CPU MODULE START- UP PROCEDURES
Table5.8 Power supply module specifications
Item
Performance Specifications
Q00JCPU (Power supply part)
Input power supply
100 to 120VAC
(85 to 264VAC)
Input frequency
50/60Hz 5%
Input voltage
distortion factor
Within 5% ( Section 5.2.3)
Max. input apparent
power
105VA
Inrush current
40A within 8ms
*5
Rated
output
current
5VDC 3A
Overcurrent
protection
*1
5VDC 3.3A or more
Overvoltage
protection
*2
5VDC 5.5 to 6.5V
Efficiency 65% or more
Allowable momentary
power failure time
*3
Within 20ms (100VAC or more)
Dielectric withstand
voltage
Across inputs/LG and outputs/FG
2830VAC rms/3 cycles (2000 m (6562 ft.))
Insulation resistance
Across inputs and outputs (LG and FG separated), across inputs and LG/FG,
across outputs and FG/LG 10M or more by insulation resistance tester
Noise durability
• By noise simulator of 1500Vp-p noise voltage, 1 s noise width and 25 to 60Hz noise frequency
• Noise voltage IEC61000-4-4, 2kV
Operation indication LED indication (The POWER LED of the CPU part: Normal: ON (green), Error: OFF)
Fuse Built-in (Unchangeable by user)
Contact output
section
No
Terminal screw size
M3.5 7
Applicable wire size
0.75 to 2mm
2
Applicable solderless
terminal
RAV1.25 - 3.5, RAV2 - 3.5
Applicable tightening
torque
0.66 to 0.89N•m
External dimensions
Section 4.1
Weight
+10%
-15%

Mitsubishi Q01CPU Specifications

General

Brand	Mitsubishi
Model	Q01CPU
Category	Controller
Language	English