Mitsubishi Q01CPU User Manual

10
LOADING AND INSTALLATION
10.3 Module Installation
10.3.1 Precaution on installation
10 - 15
9
EMC AND LOW VOLTAGE DIRECTIVES
10
LOADING AND INSTALLATION
11
MAINTENANCE AND INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
(c) Applicable DIN rail types (IEC 60715)
TH35-7.5Fe
TH35-7.5Al
TH35-15Fe
(d) DIN rail mounting screw intervals
When using DIN rail,DIN rail mounting screws should be inserted in 200 mm (7.88
inch) intervals or less in order to ensure that the rail has sufficient strength.
When installing the DIN rail in a large vibration and/or shock prone environment,
insert the mounting screws in 200mm interrals or less by the following method
show below.
<For Q38B, Q312B, Q68B, Q612B, Q38RB, Q68RB, Q65WRB, Q38DB or
Q312DB type>
Screw the DIN rail in three places using the mounting screws and square washers
included with the DIN rail mounting adaptors (hereafter referred to as the
adaptors) in ‘Position A’ (bottom of base unit).
Diagram 10.10 DIN rail mounting screw intervals
Diagram 10.11 DIN rail mounting screw intervals
35mm
(1.38 inch)
P=200mm (7.88 inch) or less
DIN rail
DIN rail mounting screw
(obtained by user)
PPP
DIN rail
35mm
P
PPP
Stopper
Stopper
A *2B *3 B *3
P=200mm (7.88 inch) or less
Mounting screws (included with adaptors)
Square washers necessary *1
Mounting screws (obtained by user)
No square washers

Mitsubishi Q01CPU Specifications

General

Brand	Mitsubishi
Model	Q01CPU
Category	Controller
Language	English