Mitutoyo ABSOLUTE ABS AT1123 - Signal Cable Preparation

7
2 Setup for Mounting
No. 99MBE095B
2.3
Preparing the Signal Cable
This section describes the conguration of the signal cable to be used with this product.
The signal cables are separately sold. Select an appropriate one according to your specications.
2.3.1 Conguration of the Signal Cable
Connect the signal cable to the electric component with one of the connectors provided on either side
of the detector head.
For the details of the connecting method, refer to
"3.4 Connecting and Fixing the Signal Cable" on
page 24.
For the specications of the signal cable, select an appropriate cable length and output connector
type.
Detector head
Signal cable (option)
Cable connecting direction: Left
Cable connecting direction: Right