Mitutoyo ABSOLUTE ABS AT1123 - Signal Cable Connection and Fixing

24
3 Mounting onto the Machine
No. 99MBE095B
3.4
Connecting and Fixing the Signal Cable
3.4.1 Cable Connection and Operation Check
An example of the system conguration is shown below.
For the details of the cables, refer to
"4 Specications" on page 29.
Signal cable (option)
DRIVE-CLiQ connection cable (Prepared by the user)
Total length including signal cable, 29 m max.
SIEMENS
DRIVE-CLiQ-support
-
ed controller

Connect the cables and check operations
1
According to "3.4.2 Connecting the Signal Cable", connect the detector head and the signal cable.
After that, connect the signal cable to the SIEMENS DRIVE-CLiQ supported controller via DRIVE-
CLiQ connection cable. After completing the cable connections, make sure the screws on the connec-
tor plug of the signal cable are fully tightened.
Tips
When connecting additional cable at your need, make sure that the total length together with the
signal cable is 29 m at maximum.
2
Turn on the power and check the operations, functions, and performance of the scale.
NOTICE
• After turning on the power, if the scale unit does not operate normally, check the connections rst. If the
scale does not operate normally even after the status of connections is checked and the power is supplied
again, investigate the cause, following the instructions in "5 Troubleshooting".
• When checking the scale operations, be very careful that no cables are being pinched by the machinery.
• When connecting the connectors, if swarf or other foreign objects are sandwiched in, that may cause mal-
functions.