18
3 Mounting onto the Machine
No. 99MBE095B
3
Fully securing the scale
After adjusting the position and checking the dimensions in the vertical direction of the scale main
unit, fully tighten the xing screws.
Note the following:
y Tightening torque: 9 N•m
y Tightening order of the screws
Be sure to tighten the full-xing parts rst, and then tighten the elastic xing parts.
Elastic xing parts Full-xing part Elastic xing parts
y Fixed state of elastic xing part
The xing state of the elastic xing part is shown below. Use this gure as a reference.
Aluminum frame SUS bushing
Special plate spring
Hex socket head cap screw, M6x30 + small round plain washer
To Next Page
Loading...
