20
3 Mounting onto the Machine
No. 99MBE095B
4
Loosen the clamp screws that x the head xing blocks with around 5 to 8 turns,
and then tilt the
clamp screws
.
(Note that if the clamp screw is loosened too much, the metal tting of the head xing
block may fall.)
State viewed from below
Head xing blocks
Loosen the clamp screws (2 places)
State viewed from below
Tilt the clamp screws (2 places)
Side view
5
Remove the head xing blocks in the direction indicated by the arrows.
State viewed from below
Slide in the direction indicated by the arrows (outside)
To Next Page
Loading...
