Mitutoyo ABSOLUTE ABS AT1123 - Page 49

39
4Specications
No. 99MBE095B
Tips
• G represents the machine guide.
• P represents the opposite side of the aluminum frame mounting surface. Also, S represents the opposite
side of the detector head mounting surface.
• Q and R represent the linear scale's reference surfaces for mounting.
• For descriptions L
0
to L
5
in the gure, refer to the next page.
• The full-xing parts are recommended to be xed at two points, A and C.
• A can be identical to the position C depending on the unit’s e󰀨ective length.
In this case, it is recommended to x at two points, A and B.
• The number of the holes at the full-xing part is di󰀨erent depending on the total length of the scale.
For details, refer to
"4.6.2 Dimensional Table" on page 40.
In the cases of 2 holes:
In the cases of 3 holes: Fix at 2 points of A and C (recommended)
Fix at 2 points of the both holes
A B C