Mitutoyo Litematic VL-50A - Removing the Worktable (for VL050 A Only)

9.2 Removing the Worktable (for VL050A only)
9.2.1 Outline
The worktable is designed to be removable.
9.2.2 Operation

Worktable
Clamp screw
Fig.003 Power Cord
(4) Ground wire: 934626
(5) Allen wrench: nominal 1.5
(for clamping contact points)/Allen wrench: nominal 3 (for removing fixtures)
(6) User’s Manual
9.2.3 Procedure

Move up the spindle to a higher position, and then turn off the power.
Turn the clamp screw counterclockwise, and then remove the worktable carefully.
To replace the worktable, reverse the procedure above.
 
IMORTANT
●When replacing the worktable, exercise sufficient care so as not to bump it against the
spindle.
●
A
void doing this work immediately before measurement. It will adversely affect the
temperature accuracy.
●Mount the worktable securely without rattle. Rattle in the worktable will adversely affect the
measuring accuracy.
No. 99MBC082B
9 - 2