UNIFLOW
®
2 PULSED THERMODE CONTROL
990-228 4-1
CHAPTER 4
OPERATING INSTRUCTIONS
Section I: Before You Start
Preparation
Before operating the Control:
x You must be familiar with the principles of reflow soldering.
x You must be familiar with the location and function of Controls and Indicators. For more
information, see Chapter 1, Description.
x Verify that all equipment has been connected properly. See Chapter 2, Installation and Setup
and the instructions supplied with the Reflow Head.
x You must be familiar with how to select and use the Control functions for your specific
applications. For more information, see Chapter 3, Using Programming Functions.
General Operator Safety
WARNING
x To prevent blindness or eye injury, wear safety goggles at all times during reflow
soldering.
x Be careful of moving parts. You can be injured by moving parts during the
reflow.
x Do not wear loose clothing or jewelry around moving parts. They could get caught
and cause injury.
To Next Page
Loading...
Need help?
General