UNIFLOW
®
2 PULSED THERMODE CONTROL
990-228 vii
SAFETY PRECAUTIONS
General
This instruction manual describes the operation and maintenance of the Control and
provides instructions relating to its safe use. Procedures described in this manual must be
performed as detailed by Qualified and Trained personnel.
For Safety, and to effectively take advantage of the full capabilities of the Control, please
read this instruction thoroughly before attempting to use it.
After reading this manual, retain it for future reference when any questions arise
regarding the proper and safe operation of the Control.
Operation
Procedures other than those described in this manual or not performed as prescribed in
this manual, may expose personnel to electrical shock or DEATH.
When operating any Reflow unit, always wear appropriate personal protective gear.
Maintenance/Service
Before performing any maintenance on the Control unit, read Chapter 5, Maintenance
thoroughly. Use the appropriate tools for terminating the connecting cables, being
careful not to nick the wire conductors.
Do not modify the Control without prior written approval from Unitek Miyachi.
HIGH VOLTAGE is used in the operation of this equipment.
DEATH ON CONTACT may result if personnel fail to observe the
safety precautions labeled on the equipment and noted in this manual.
WHEN REFLOWING always wear safety glasses.
To Next Page
Loading...
Need help?
General