UNIFLOW
®
2 PULSED THERMODE CONTROL
viii 990-228
Before using this equipment, read the
SAFETY PRECAUTIONS carefully to
understand the correct usage of the
equipment.
x These precautions are given for safe use
of the equipment and for prevention of
injury to operators or others.
x Be sure to read each of the instructions,
as they are all important for safe
operation.
x The meanings of the words and symbols
are as follows:
DANGER
DO NOT TOUCH THE INSIDE OF THE CONTROL UNNECESSARILY.
High Voltages are present inside the Control Cabinet. Do not touch the inside of the Control
unnecessarily with the power turned ON. You may receive an electric shock. When
inspecting the inside of the Power Supply, be sure to turn the power source OFF.
NEVER DISASSEMBLE, REPAIR, OR MODIFY THE CONTROL.
These actions can cause electric shock and fire. Do not do anything other than the
maintenance described in the Operator Manual.
To Next Page
Loading...
Need help?
General