UNIFLOW
®
2 PULSED THERMODE CONTROL
990-228 ix
WARNING
Do NOT put your hands or fingers on the Thermode.
When soldering, keep your hands and fingers away from the thermode.
Do NOT touch any soldered part or Thermode during, or just after reflow soldering.
The soldered parts and the Thermode are very hot. If you touch them you may be burned.
Ground the equipment.
If the equipment is not grounded, you may get an electric shock.
Use a ground fault breaker.
Use a ground fault breaker to prevent an electric shock.
Only use specified cables.
A cable with insufficient capacity or loose connections can cause electric shock or fire.
Do NOT use a damaged power cable, connecting cables, or plugs.
Do not step on, twist, or tense any cable. The power cable and connecting cables may be
damaged which can cause electric shock, short circuit, or fire. If any part needs to be
repaired or replaced, consult Unitek Miyachi or your distributor.
Stop operation if any trouble occurs.
If you detect a burning smell, abnormal sounds, abnormal heat, smoke, etc., turn power
OFF immediately to prevent fire or electric shock. Contact Unitek Miyachi or your distributor
for help.
People with pacemakers MUST stay away from the Control.
When the Control is operating, it generates a magnetic field, which adversely affects
pacemakers. People who use a pacemaker must not approach the Control, or walk around
the soldering shop while the Control is operating, unless their medical doctor has deemed it
safe to do so.
Wear protective gear.
Put on protective gear such as protective gloves, long sleeved jacket, and leather apron to
avoid being burned.
To Next Page
Loading...
Need help?
General