Money Control SR3 User Manual

SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
This document is the copyright of Money Controls Ltd and may not be reproduced in part or in total by any means,
electronic or otherwise, without the written permission of Money Controls Ltd. Money Controls Ltd does not accept
liability for any errors or omissions contained within this document. Money Controls Ltd shall not incur any
penalties arising out of the adherence to, interpretation of, or reliance on, this standard. Money Controls Ltd will
provide full support for this product when used as described within this document. Use in applications not covered
or outside the scope of this document may not be supported. Money Controls Ltd. reserves the right to amend,
improve or change the product referred to within this document or the document itself at any time.
Money Controls 2005. All rights reserved.

Money Control SR3 Specifications

General

Brand	Money Control
Model	SR3
Category	Cash Counters & Coin Sorters
Language	English

Summary

Parallel Interface

Credit Codes

DIL Switch Options

DIL Switch Functions

Lists the functions controlled by the 6-way DIL switch for field programming.

DIL Switch Guide and Notes

Provides a guide to DIL switch settings and a critical note on test credit accumulator mode.

Accept and Inhibit Configuration

To Inhibit Specific Coins

Describes the procedure to inhibit specific coins using DIL switches and reject lever.

To Enable Specific Coins

Details the process to enable specific coins using DIL switches and reject lever.

Bank Select

Both Banks ON

Explains how to enable both coin banks using DIL switches and reject lever.

Bank 1 ON Bank 2 OFF

Details enabling bank 1 and disabling bank 2 using DIL switches.

Bank 1 OFF Bank 2 ON

Details disabling bank 1 and enabling bank 2 using DIL switches.

Teach and Run™™ Option

Programming Steps

Outlines the 6 steps required to program a coin or token using Teach & Run.

BANK 1 Programming

BANK 2 Programming

Erase All Windows

Adjustable Coin Security

DIL Switch Functions for Security

Explains the role of DIL switches in adjusting coin security settings.

Decrease Security

Details DIL switch settings for decreasing coin security.

Increase Security

Details DIL switch settings for increasing coin security.

Reset Security

Explains how to reset security settings to default values.

Alarms

Sorter Option

Sorter Mode 1 (default)

Describes the default sorter mode providing a logic signal to drive solenoids.

Sorter Mode 2

Explains sorter mode 2 where credit code is output before gate activation.

Sorter Mode 3

Details sorter mode 3 with a delayed 'early' credit pulse.

Sorter Drivers

Sorter Drive Circuit

Shows the circuit diagram for the SR3's low current sorter driver output.

THEORY OF OPERATION

Sorter Drive Examples

Sort Outputs v Sorter Paths

Totaliser Mode

19 way Parallel Interface Connector

CMETER

Player 1 HI / Player 1 LO

Player 2 to 4

Dispense 1 to 4

Totalising Options

Totalising DIL Switch Guide

Lists DIL switch settings for totalising functions like game price and bonus levels.

Set a Game Price

Set Bonus Level 1

Set Bonus Level 2

Set Bonus Award Level 1

Set Bonus Award Level 2

Totalising Parameters

Totalising Parameters Explanation

Protocols

Serial Interface

ccTalk Serial Messages

Error and Fault Codes

ccTalk Interface Circuits

Circuit 1 - ccTalk Standard Interface

Circuit 2 - ccTalk Low Cost Interface

Circuit 3 - ccTalk Direct Interface

Circuit 4 - ccTalk PC Interface

Fault Finding

Fault Finding Guide

A table guiding users through troubleshooting symptoms, investigations, and possible causes.

Electrical Interface Requirements