SR3 Type 1 Technical Manual TSP005.doc Issue 5.0 – Jan 2005
Money Controls 2005. All rights reserved.
Page 20 of 50
12. Erase All Windows
This function allows you to erase all the windows previously programmed, whether they were
programmed by Teach and Run
TM
, programmed using a programming device or programmed
by Money Controls Ltd.
Because of the severity of this procedure, two steps are required, which reduces the risk of this
being done accidentally.
Switch off the power to the SR3.
Set the Program DIL switches to:-
SW1 SW2 SW3 SW4 SW5 SW6
OFF
ON
OFF
ON
OFF OFF
Switch on the power to the SR3.
Press the reject lever within 20 seconds.
The LED will flash RED / GREEN.
Set the Program DIL switches to:-
SW1 SW2 SW3 SW4 SW5 SW6
ON
OFF OFF OFF OFF OFF
Press the reject lever again.
The LED will flash GREEN.
Set ALL the DIL switches to the OFF position.
Press the reject lever to return to operational mode.
LED will change to constant GREEN.
To Next Page
Loading...